DIY CNC X Y Z Axis Linear Stage Slide Kit 8.25 Travel with driver and motor
Used on a DIY CNC router positioning a 2.5 Hp router. The smaller motor shown in video youtube.V=jIcRBqyoNi0&t=3s was replaced because it was marginal, the replacement is listed below. 2MA860H not pictured but included.
N = NEMA (n/a 4stacks). H = Winding leads h = 4 Lead Parallel. Rotor type = L = laminated. Shaft Configuration = n = single. Shaft Modifications N = Smooth.S = same as above. 00 = standard motor no seal. Holding torque (2 phases on) oz-in (Nm) 940 (6.64). Rated Current/Phase (A) 8.6. Phase Resistance (ohms) +- 10% 0.23.
- Stroke Length: 200mm (8 in)
- Brand: Unbranded
- Voltage: see driver spec listed below